SUMMARY: failed to boot after jumpstart ??

Andy Ford andy.ford at telindus.co.uk
Fri Jun 18 01:58:48 EDT 2004


This was exactly the issue.
I did a set-defaults and a reset-all from the OBP and it has continued
with the jumpstart.

Thanks to all who responded

Andy

-----Forwarded Message-----
From: Joe Kabbabe <jkabbabe at svtr.com>
To: Andy Ford <andy.ford at telindus.co.uk>
Subject: RE: failed to boot after jumpstart ??
Date: Thu, 17 Jun 2004 11:00:42 -0700

At the OK> prompt, type 'printenv' and if the value of 'diag-switch?' is true, then check the value of 'diag-file'.  If the value of 'diag-switch?' is false, then check the value of 'boot-file'.  Try 'set-defaults', then 'reset-all'.

Joseph Kabbabe
Sun Valley Technical Repair, Inc.
Specializing in Purchases - Sales - Repairs
SUN * IBM * Cisco * Hitachi
15555 Concord Circle, Morgan Hill, CA 95037, USA
Tel: (408)825-1736
Fax: (408)825-1636
Yahoo IM: joeksvtr
AOL IM: joeksvtr


-----Original Message-----
From: Andy Ford [mailto:andy.ford at telindus.co.uk]
Sent: Thursday, June 17, 2004 4:33 AM
To: sunmanagers at sunmanagers.org
Subject: failed to boot after jumpstart ??


Hi everyone

I am trying to jumpstart a V120 with Solaris 9 4/04.
The jumpstart gets as far as the finish script, it then reboots and
comes up with the following message....
------------
Rebooting with command: boot 
Boot device: disk:a File and args: ""
boot: cannot open ""
Enter Filename [""]:
-----------

What am I missing?
And which file is it looking for?

Thanks

Andy
_______________________________________________
sunmanagers mailing list
sunmanagers at sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers



More information about the summaries mailing list